








Bailey Metals

Bailey Universal Bridging Clip is a unique patented design engineered for rapid, economic installation with Bailey bridging channel in both curtain and load bearing steel stud designs. Installs rapidly with #8 or #10 screws in pre-punched holes.
Available Sizes: UBC 365, UBC 600 AND UBC 800

Aluminum Burn Clips are used as part of the H-Stud Area Separation Wall assembly and are designed to melt and break away when exposed to fire. The clips are used to hold the area separation wall assembly in place at the floor, roof and truss line between adjacent units.

BAILEY TOP DEFLECTION CLIP TDC 350 AND TDC 587
Used on exterior curtain wall studs to allow for building structure deflection at the top of the wall. BAILEY TOP DEFLECTION CLIPS can also be used
for non-load bearing interior wall requirements.

BAILEY HFA CLIP is a low cost method to accommodate the vertical deflection in exterior by-pass curtain wall conditions.
• Allows for vertical movement of the structure independent from the exterior curtain wall framing
• Eliminates the need for mechanical fastening between the clip and the steel stud
• If the design requires a stand off distance, an additional steel stud should be used to eliminate the stand-off and establish the connection

H-Studs are 2" wide vertical members used to secure two 1" thick pieces of gypsum shaft liner in Area Separation Wall assemblies. H-Studs are inserted into C-Runners and slid over gypsum panel liner edges. The process is repeated until the desired wall length is achieved.
• 2-hour fire-rated assembly
• 2" wide, 25 gauge (18mil)
• Tested and approved with most major gypsum and shaft liner manufacturers
• Stock lengths are 8', 10' and 12'

C-Runner, also referred to as H-Track, is used to secure H-Stud and gypsum shaft liner panels in area separation wall assemblies. C-Runner is attached to the foundation with power-driven fasteners. C-Runner is also used as top track to cap the H-Stud and gypsum shaft liner panels.
• 2-hour fire-rated assembly
• 2" wide, 25 gauge (.018)
• Tested and approved with most major gypsum and shaft liner manufacturers
• Standard 10' stock lengths